Any help or advice you could give would be appreciated. Is this the correct setting for the finecut consumables? This is the first time I have messed with them. I was running the machine at the voltage it says in the manual but slowing the speed down to 150 ipm. I don't however want to have to purchase a single line font since I have CorelDrawX5 along with all the extra fonts that come with it. I have been told that letters the size I am wanting are possible on the machine that I own. I am using CorelDraw to design these cards. A couple letters will come out ok but then it just starts turning in to ragged holes. I am using a Hypertherm Powermax 65 with the finecut consumables and just can't seem to get it to work. This would speed up the process considerably and offer me near the same effect. My next thought was to cut the letters with no offset as a single line. I have an engraver but the problem with that is it takes 13 minutes per card. So, I have this brilliant Idea to do my business cards on the CNC plasma table.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |